![background image](http://html1.mh-extra.com/html/land-pride/wc1503/wc1503_operators-manual_673000021.webp)
Section 1: Assembly & Set-Up
11/15/19
17
Driveline Installation
Refer to Figure 1-3 on page 16:
1. Remove lower locknuts (#3) and bolts (#2). Rotate
drive shaft shield (#1) up.
2. Remove shaft protector (#9) from drive shaft (#8).
3. On shear bolt end of driveline (#10), push push-pin in
and hold while starting to slide universal joint onto
drive shaft (#8).
4. After universal joint starts onto the drive shaft,
release push-pin and continue to slide universal joint
on until push-pin releases and universal joint locks in
place. Move driveline back and forth to ensure it is
secured to the drive shaft.
5. Rotate drive shaft shield (#1) down and secure with
bolts (#2) and locknuts (#3). Draw locknuts up snug.
IMPORTANT:
The driveline must be lubricated
before putting it into service. Refer to
Tractor Shutdown Procedure
The following are basic tractor shutdown procedures.
Follow these procedures and any additional shutdown
procedures provided in your tractor Operator’s Manual
before leaving the operator’s seat.
1. Reduce engine speed and disengage power take-off
if engaged.
2. Park tractor and implement on level, solid ground.
3. Lower implement to ground or onto non-concrete
support blocks.
4. Put tractor in park or set park brake, turn off engine,
and remove switch key to prevent unauthorized
starting.
5. Relieve all hydraulic pressure to auxiliary hydraulic
lines.
6. Wait for all components to come to a complete stop
before leaving the operator’s seat.
7.
Use steps, grab-handles and anti-slip surfaces when
stepping on and off the tractor.