Section 1: Assembly & Set-up
1/25/21
STB0554 & STB0560 Snow Trip Blade 301-701M
13
Hydraulic Angle-Single Cylinder Assembly
Refer to Figure 1-5:
1. Attach base end of cylinder (#3) to hitch assembly
lug (#5) with clevis pin (#2) and cotter pins (#1).
2. Attach rod end of hydraulic cylinder (#3) to pivot
weldment lug (#7) with clevis pin (#9) and
cotter pin (#8).
3. Remove cylinder port plugs.
4. Locate adapter (#10) with a small orifice opening in
one end. Attach that adapter to the rod end of
hydraulic cylinder (#3). Attach the other adapter (#4)
to the base end. Tighten adapters.
5. Attach hoses (#6) to adapters (#10) and (#4) and
tighten.
6. Thread two 5/16"-18 hex nuts (#12) to U-bolt (#11).
7. Place U-bolt (#11) through the holes in hitch
weldment (#14) and fasten with two 5/16"-18 hex
nuts (#13).
8. Wrap hoses (#6) together with hose wrap (#15).
9. Thread hoses (#6) through U-bolt (#11).
NOTE:
U-bolt (#11) can be angled to the left or right
or it can be centered.
NOTE:
Wrap hose wrap (#15) to hoses (#6) so that
the hose wrap (#15), not the hoses (#6), comes in
contact with U-bolt (#11).
Hydraulic Angle-Single Cylinder Assembly
Figure 1-5
3
5
2
1
8
9
10
4
7
6
13
11
12
14
74861
15
Orifice Fitting
