Land Pride RGR12 Series, Operator'S Manual

Page: 29 / 40

Section 4: Maintenance and Lubrication
Table of Contents
RGR12 & RGA12 Series Rotary Tillers 311-948M 1/7/19
25
Clutch Assembly
Refer to Figure 4-4 on page 24:
Reassemble each friction disk (#4) next to the metal
clutch plate it was separated from. Make certain
bushing (#5) is replaced in the same location as when
removed. Install bolts (#3) through end plates and
intermediate plates as shown. Place springs (#2) over
each bolt and secure with nuts (#1).
Clutch Spring Length
Figure 4-5
Refer to Figure 4-5:
Progressively tighten each spring retainer bolt until
correct spring height (“A” dimension) is reached.
30559
A = Measured length of each spring
before disassembling slip clutch.
Use 1.14" for “A” dimension if
measurements were not taken.