Section 2: Set-Up of Accessories
1/13/21
18
Skid Shoe
Kit Bundle
(Pair of skid shoes)
301-333A . . . . . . . . . . . . . . . . SKID SHOE ASSEMBLY
Refer to Figure 2-5:
The skid shoes are attached to both ends of the blade to
help prevent damage to the surface of the ground by the
blade.
1. Remove two 5/8"-11 x 1 3/4" GR5 plow bolts (#1)
from the end of the blade. Keep hardware for
installation of skid shoes.
2. Attach skid shoe bracket (#3) with 5/8"-11 x 1 3/4"
GR5 plow bolts (#1), flat washers (#2), and hex
flange locknuts (#4). Tighten hardware to the correct
torque.
3. Insert skid shoe (#5) into skid shoe bracket (#3).
Secure with bent pin (#6) and hairpin cotter (#7).
4. Repeat steps 1 through 3 for the other side.
Skid Shoe Assembly
Figure 2-5
25535
End Plates
Kit Bundle (Pair of End Plates)
301-147A . . . . . . . . . . . . . . . . . . . . . . . . . .END PLATES
Refer to Figure 2-6:
End plates are attached to both ends of the blade,
eliminating spillage when moving snow or loose material.
1. Attach right-hand end plate (#3) to the moldboard as
shown with two 5/8"-11 x 2" GR5 hex head cap
screws (#4), spring lock washer (#7), and hex nuts
(#8). Draw hex nuts up snug. Do not tighten.
2. Attach side plate support strap (#2) with two
1/2"-13 x 1 1/4" GR5 hex head cap screws (#1), lock
washers (#5), and hex nuts (#6). Draw hex nuts up
snug. Do not tighten
3. First tighten hex nuts (#8) to the correct torque and
then next nuts (#6) last.
4. Repeat steps 1 through 3 for the left-hand end plate.
.
End Plate Assembly
Figure 2-6
NOTE:
Alternate tightening of bolts when installing
mounting hardware. Some deflection may occur in
moldboard.
12550
