Section 1: Assembly & Set-Up
1/13/21
12
Blade Angling Cylinder
Refer to Figure 1-4:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two 90 degree elbows (#4) into the
cylinder ports as shown. Tighten as needed.
2. Screw 74" long hydraulic hose (#6) into elbow (#4) at
the cylinder base and tighten.
3. Screw 82" long hydraulic hose (#5) into elbow (#4) at
the cylinder rod end and tighten.
4. Thread adapter fittings (#7) to the other end of the
hydraulic hoses and tighten.
5. Thread quick disconnect couplers (#8) to adapter
fittings (#7).
6. Attach hydraulic cylinder to the lugs on the right side
of the frame with clevis pins (#1). Make sure
hydraulic ports are positioned on top and the cylinder
base in positioned to the front as shown.
7. Secure clevis pins with hair pin cotters (#2).
8. Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to tractor's
hydraulic system.
Hydraulic Blade Angling
Figure 1-4
IMPORTANT:
Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
24994
Blade Offset Cylinder
Refer to Figure 1-3:
WARNING
!
To avoid serious injury or death:
Do not remove shipping block from blade tilt housing until
after all manual links, ratchet jack, and/or hydraulic cylinders
have been installed and cylinders have been charged with oil.
Assemble hydraulic hoses to the hydraulic cylinder
before placing cylinder on the blade.
1. Position hydraulic cylinder (#3) with ports on top as
shown. Install two 90 degree elbows (#4) into the
cylinder ports as shown. Tighten as needed.
2. Screw 74" long hydraulic hose (#6) into elbow (#4) at
the cylinder base and tighten.
3. Screw 82" long hydraulic hose (#5) into elbow (#4)
located at the cylinder rod end and tighten.
4. Thread adapter fittings (#7) to the other end of the
hydraulic hoses and tighten.
5. Thread quick disconnect couplers (#8) to adapter
fittings (#7).
6. Attach hydraulic cylinder to lugs located on left side of
3-Way Rear Blade with clevis pins (#2). Make sure
hydraulic ports are positioned on top and the cylinder
base in positioned to the front as shown.
7. Secure clevis pins with hair pin cotters (#1).
8. Route hoses through hose bracket located on the
right side of the front hitch. Connect hoses to tractor's
hydraulic system.
Hydraulic Blade Offsetting
Figure 1-3
IMPORTANT:
Attach cylinder base to the front
cylinder mount. The base will interfere with the
mainframe if attached to rear cylinder mount.
24993
