Land Pride RCR2596 Series, Operator'S Manual

Page: 47 / 56

43
Section 5: Maintenance & Lubrication
RCR2596, RCR2510, and RCRM2510 Rotary Cutters 312-753M
Table of Contents
7/29/20
T-Gearbox
Check oil level in gearbox by removing lower rear plug in
gearbox case. If oil is below lower rear plug hole, add
recommended gear lube through top plug hole until oil
flows out of rear plug hole. Reinstall oil plugs and tighten.
Type of Lubrication: 80-90W EP Oil
Quantity = Fill until oil flow from upper rear port of
gearbox case.
NOTE:
Do not overfill! Cutter should be level when
checking oil.
8
Hours
Gearbox
Remove side oil plug. If oil is below bottom of plug hole,
add recommended gear lube through top vented plug
hole until oil flows out of side plug hole. Reinstall and
tighten side oil plug and top vented plug.
Type of Lubrication: 80-90W EP Gear Lube
Quantity = Fill until oil reaches top mark on dipstick or
begins to flow out side plug hole in gearbox.
NOTE:
Do not overfill! Cutter should be level when
checking oil. Oil expands when hot, therefore,
always check oil level when cold.
Do Not Overfill
33418
Vented Plug
IMPORTANT: This implement is shipped with a vented
dipstick packaged in the Operator’s Manual bag and
should have been installed in the gearbox by your
dealer. Please consult your dealer if vented dipstick
was not included.
NOTE: Use a suction or siphon pump to drain gearbox
of oil when there is not an oil drain plug.
33419
Do Not Overfill
IMPORTANT: This implement is shipped with a
vented dipstick packaged in the Operator’s Manual
bag and should have been installed in the gearbox by
your dealer. Please consult your dealer if vented
dipstick was not included.
NOTE:
Use a suction or siphon pump to drain gearbox
of oil when there is not an oil drain plug.
35008
Dual End Flex Coupler
Type of Lubrication: Grease
Quantity = As required
8
Hours
8
Hours