Land Pride RCR2596 Series, Operator'S Manual

Page: 19 / 56

15
Section 1: Assembly & Set-up
RCR2596, RCR2510, and RCRM2510 Rotary Cutters 312-753M
Table of Contents
7/29/20
3. Remove nuts (#10), lock washers (#9), and clamp
bolts (#8) from slip-clutch end of driveline (#2).
4. Slide slip-clutch end of driveline onto gearbox input
shaft until hole in yoke aligns with notch in shaft.
5. Insert 2- bolts (#10) through holes in driveline yoke
as shown and secure with lock washers (#9) and
nuts (#10). Tighten bolts to 45-50 ft-lbs of torque.
6. Push/pull on driveline yoke to be sure it is securely
fastened to the gearbox shaft.
7. Insert jackshaft of driveline (#2) through bearing
support assembly (#3). Pull bearing support
assembly fully against driveline (#2) to extend
jackshaft splines fully through the bearing.
8. Attach main driveline (#4) to jackshaft of
driveline (#2) by pulling on locking collar and pushing
driveline yoke forward onto the jackshaft until locking
collar has locked in place. Push/pull on driveline yoke
to be sure it is securely fastened to jackshaft (#2).
9. Tighten set screw in bearing locking collar (#3).
10. Rotate gearbox shield access doors (#7) closed and
snap in place.
NOTE:
Make sure locking collar on bearing (#3) is
facing rearward toward the cutter gearbox.
RCR2596, RCR2510 & RCRM2510
Equal Angle Driveline Assembly
Figure 1-6
22303
Equal Angle Driveline Installation
Refer to Figure 1-6:
Equal angle drivelines can be installed on RCR2596,
RCR2510, and RCRM2510. Maximum turning angle is
limited to 35 degrees.
DANGER
!
To avoid serious injury or death:
Make certain driveline yokes are securely fastened at each
end. A loose yoke can work free allowing the driveline to
rotate uncontrollably causing implement damage and bodily
injury or death to anyone nearby.
WARNING
!
To avoid serious injury or death:
Maximum equal angle driveline turning angle is limited to 35
degrees. Exceeding this angle can cause the driveline to break
and send flying objects.
1. Unsnap one end of gearbox shield access doors (#7)
and rotate doors open.
2. Remove protective sleeve (#11) from input shaft of
gearbox (#1) and discard.
IMPORTANT: The driveline must be lubricated
before putting it into service. Refer to
“Lubrication
Points” on page 42.