![background image](http://html.mh-extra.com/html/land-pride/rc5014/rc5014_operators-manual_672964030.webp)
28
Section 5: Maintenance & Lubrication
RC5014 (540 RPM) and RCM5014 (1000 RPM) Rotary Cutters 330-117M
2/02/08
Land Pride
4-Plate Assembly
Step 2
Compress Belleville Springs
to the pressure plate by
tightening the four hex nuts
and then placing the
assembly into the clutch
housing.
Step 3
Bend retaining lugs inward
over the Belleville Spring
edges to secure the spring
before backing the four hex
nuts off.
Step 4
With lugs bent in, loosen the
four hex nuts completely to
the end of the threaded studs.
Step 5
Install end half clamps if
available.
Step 1
Place hub and friction discs
into the housing.
23553
Skid Shoe Maintenance
!
WARNING
Excessive wear on skid shoes may cause inadequate operation
of cutter and create a safety hazard!
There are two skid shoes mounted on either side of the
center section and one skid shoe mounted on each wing
section. Check all skid shoes for wear and replace if
necessary. Order only genuine Land Pride parts from
your local Land Pride Dealer.
Center Skid Shoe
Refer to Figure 5-9:
Replace center skid shoes as follows:
1.
Remove 1/2"-13 hex whiz nuts (#2), 1/2" -13 x 2”
GR8 hex bolts (#3) and center skid shoe (#1) as
shown.
2.
Attach new skid shoe (#1) to cutter with existing
1/2” hex bolts (#3), existing top plate (#4) and secure
with existing 1/2" hex lock nuts. Torque to 105 ft. lbs.
3.
Repeat on opposite side of center section.
Center Skid Shoe
Figure 5-9
Land Pride Skid Shoe Replacement Parts
Part No.
Part Description
318-145H
CENTER SKID SHOE (RH)
318-146H
CENTER SKID SHOE (LH)
318-335D
WING SKID SHOE
802-466C
PLOW BOLT, 3/8" - 16 x 1 1/1/4" grade 5
23568