Land Pride RB3772, Operator'S Manual

Page: 14 / 28

Section 2: Accessory Equipment Set-Up
Table of Contents
11/27/18 RB3772, RB3784, & RB3796 Rear Blades 301-457M
10
Skid Shoes
Figure 2-2
Skid Shoes
Kit Bundle (Pair of skid shoes)
301-333A . . . . . . . . . . . . . . . . . SKID SHOE ASSEMBLY
Refer to Figure 2-2:
Skid Shoes (#1) can be attached to both ends of
moldboard to help prevent cutting blade from damaging a
surface being cleared by the blade.
1. Remove existing hex flange locknuts (#7) and
1 3/4" long plow bolts (#4) on one end of
moldboard (#3).
2. Attach skid shoe mount (#2) to moldboard (#3) with
two 5/8"-11 x 2 1/2" GR5 plow bolts (#5), flat
washers (#8), lock washers (#9), and hex nuts (#6).
Tighten hex nuts to the correct torque.
3. Insert skid shoe (#1) into skid shoe mount (#2) and
secure with bent pin (#10) and hairpin cotter (#11).
4. Repeat steps 1-3 above for the opposite end of
moldboard (#3).
35455
.
End Plate Assembly
Figure 2-3
End Plates
Kit Bundle (Pair of End Plates)
301-010A . . . . . . . . . . . . . . . . . . . . . . . END PLATE KIT
Refer to Figure 2-3:
End Plates can be attached to both ends of moldboard to
help contain material while moving material from one
location to another.
1. Attach end plate (#1) to moldboard (#2) as shown
with two 1/2"-13 x 1 1/2" GR5 hex head cap
screws (#3), spring lock washers (#5), and hex
nuts (#4). Tighten hardware to the correct torque.
2. Repeat step 1 for opposite end of moldboard (#3).
35456