Section 1: Assembly & Set-up
9/28/18
RB1660, RB1672, RB1684, RB2672, RB2684, & RB2696 Rear Blades 301-375M
9
Check Clearances
1.
Make certain blade offset is adjusted to the field
setting before checking blade clearances. Refer to
on page 14 for offset instructions.
2. With Rear Blade hitched to a tractor, raise blade off
the ground and angle blade as far as possible
towards the right rear tractor tire. Refer to
on page 13 for angling instructions.
3. Slowly raise 3-point arms fully up and down to make
sure blade does not make contact with tractor tire
and drawbar.
a. Move or remove drawbar if it interferes with blade.
b. Set tractor control lever stop to restrict lifting
height if blade interferes with tractor tire.
4. Tilt end of blade closest to the tractor tire fully up and
repeat step 3 above. Refer to
“Blade Tilting”
on
page 13 for tilt instructions.
5. Tilt end of blade closest to the tractor tire fully down
and repeat step 3 above.
6. Return
“Manual Angling”
and
“Blade Tilting”
to
center position.
7.
Angle blade as far as possible towards the left rear
tractor tire and repeat steps 3 through 6