Section 2: Options, Assembly & Set-Up
1/13/21
RBT3584 & RBT3596 Rear Blades 301-251M
19
Cushion Valve (Accessory)
Refer to Figure 2-8:
CAUTION
!
To avoid minor or moderate injury:
Do not operate Rear Blade with angling or offset cylinder
fully extended. Fully extending either cylinder will keep
cushion valves from operating correctly.
1. Mount cushion valves (#1 & #2) onto the mounting
plate with 3/8"-16 x 4" GR5 hex head cap screw (#3),
spring lock washer (#4), and hex hut (#5). Tighten
hex nuts to correct torque.
2. Screw eight fittings (#6) into both cushion
valves (#1 & #2) until tight.
3. Attach hydraulic hose (#7) to the rear right fitting of
cushion valve (#2) as shown.
4. Attach hydraulic hose (#8) to the front right fitting of
cushion valve (#1) as shown.
5. Attach hydraulic hose (#9) to the rear left fitting of
cushion valve (#1) as shown.
6. Attach hydraulic hose (#10) to the front left fitting of
cushion valve (#2) as shown.
7. Attach the four hydraulic hoses (#11) included with
this option to the remaining cushion valve fittings and
thread them through hose retainer (#12).
Hydraulic Cushion Valve Assembly
Figure 2-8
24751
Blade Angling Cylinder:
Connect these two hoses
to a duplex outlet.
Blade Offset Cylinder:
Connect these two hoses
to a duplex outlet.
Blade Offset
Cylinder
Blade Angling
Cylinder
