16
Section 1: Assembly & Set-up
NTS2607, NTS2609, & NTS2611 No-Till Seeder 329-141M
9/10/20
Tow Hitch Option
Refer to Figure 1-7:
1. Attach hitch (#1) to lower 3-point clevises with hitch
pins (#6). Secure hitch pins with linchpins (#4).
2. Remove detent pin (#12) and rotate park jack (#11) in
jack mount “A” until near vertical. Fully insert detent
pin (#12) through park jack and park jack mount.
3. Extend or retract park jack (#11) until rod end of
hydraulic lift cylinder (#7) is in align with hole “B” in
the hitch lug.
4. Insert clevis pin (#5) and secure with flat washer (#2)
and cotter pin (#3). Bend one or more legs of cotter
pin to keep pin from falling out.
5. Coil hydraulic hoses (#8 & #9) and wire
harness (#10). Store coiled loops on the seeder.
IMPORTANT:
Do not raise spike rollers off the
ground with park jack (#11).
Tow Hitch Option Assembly
Figure 1-7
73356
Acremeter Option
Refer to Figure 1-8 on page 17:
1. Remove upper guard (#26) as follows:
a. Remove bolt (#15), lock washer (#21), flat
washer (#20), hand knobs (#25) and guard (#26).
b. Set guard (#26) and attaching hardware
(#15, #20, #21, & #25) aside for reuse later.
2. Remove lower guard (#6) as follows:
a. Remove bolts (#15), flat washers (#21), and
guard (#6).
b. Set guard (#6) and attaching hardware
(#15 & #21) aside for reuse later.
3. Loosen nut (#18) securing idler sprocket (#24) and
remove roller chain (#28).
4. Loosen nut (#18) securing idler sprocket (#2) and
remove roller chain (#27).
NOTE:
Refer to
“Electronic Acremeter (Option)”
on page 56 and instruction manual no. 194-074M for
detailed programming and operating instructions.
NOTE:
Keep greasable pivot bolt (#7) and all-seeds
drive sprocket with lockout clutch (#5) together.
