Land Pride FPS48, Operator'S Manual

Page: 15 / 38

Section 1: Assembly & Set-up
FPS48 Plot Ranger Food Plot Seeder 322-118M 12/7/18
11
Table of Contents
Refer to Figure 1-5:
8. Attach one end of a ratchet tie down strap to the
spreader eyebolt (F) and the other end to the front
hole (G) located on the left side of the disc frame as
shown in Figure 1-5. Tighten strap only enough to
remove slack.
9. Attach a second tie down strap to the same spreader
eyebolt (F) and to hole (H) located on the right side of
the disc frame as shown in Figure 1-5. Tighten strap
only enough to remove slack.
10. Tighten both tie down strap equally to prevent
spreader box from jiggling in its mount. Do not over
tighten.
CAUTION
!
To avoid minor or moderate injury:
Make sure electrical wiring is supported in such a way that it
will not make contact with trash, lift mechanism, rotating
discs, pinch points, vehicle rotating components, vehicle hot
exhaust, etc.
Plot Ranger Assembly
Figure 1-5
F
5
5
23916
Tie Down Straps
G
H
Wrap Electrical
Wiring As shown
Refer to Figure 1-4 on page 10:
11. Store hand controller (#12) in a dry location. The
following steps are required if installing at set-up:
a. Thread hand control wires with white connector
(A) and black connector (C) through eye bolt (F).
b. Plug white connector (A) into the feedgate
connector (B) and black connector (C) into the
spin motor connector (D).
c. Wrap wires around one of the tie down strap and
along the hitch frame as shown in Figure 1-5
below.
d. Plug lighter plug (E) into a 12 volt accessory
receptacle.
Refer to Figure 1-5:
NOTE: Ties (#5) may be used to secure electrical
wiring. If ties are used, attach them loosely or out of
material that can be removed easily to allow easy
removal of electrical components for dry storage.