Default:
50
Storage:
&W
Command Values:
AT+LCIDCT=
<timeout>
Where <timeout> is a number between 0 and 65535
seconds.
8.3 AT+LCSEST Session Disconnect Timer
This command is used to configure the Session Disconnect timeout used by the PAD
service. Session will be unconditionally closed and the usual disconnect response
generated at the expiration of this timer. A value of 0 disables the Session Disconnect
Timer.
Default:
0
Storage:
&W
Command Values:
AT+LCSEST=
<timeout>
Where <timeout> is a number between 0 and 65535
seconds.
9.0 Ethernet Commands
The commands below are used to configure the RJ45 Ethernet port. There is no error
checking beyond octet validation (Four octets of 0-255) for any of the ethernet address
assignments. E.g. If you set the netmask to an invalid address, the modem will accept it
but may unable to transfer via the RJ45 port.
9.1 AT+LCETHI Set The Local Ethernet IP
This command will set the local IP of the ethernet port.
Default:
192.168.1.222
Storage:
&W
Command Values:
AT+LCETHI=
<IP Address> Sets the ethernet IP.
AT+LCETHI?
Queries the current ethernet IP.
9.2 AT+LCETHN Set The Local Ethernet Netmask
This command will set the netmask of the ethernet jack.
Default:
255.255.255.0
Storage:
&W
Command Values:
AT+LCETHN=
<Netmask>
Sets the ethernet netmask.
AT+LCETHN?
Queries the ethernet netmask.
9.3 AT+LCETHG Set The TCP/IP Gateway
