2.) Connection Type:
0=SIP Only
1=Mobile IP Only
3.) Phone Number To Dial:
atd#777
-For High-Speed Data Calls
4.) Username:
Username For This Connection
5.) Password:
Password For This Connection
6.) Transport Method:
0=TCP Connection
1=UDP Connection
7.) Modem Functionality:
0=Modem Will Act As A Client
1=Modem Will Act As A Server
8.) Local serial protocol:
0=No encoding, data is sent without any
encapsulation
1=Encode with Addressed Serial Protocol
(
See section 18.1 for details)
8.) IP Connection:
Where:
vvv.www.xxx.yyy - The IP To Connect To
When Acting As A Client
vvv.www.xxx.yyy - The Trusted Incoming IP
To Listen To When Acting As Server
9.) Port Connection:
zzzzz - Port To Connect To When Acting As A
Client.
zzzzz - Trusted Incoming Port To Listen To
When Acting As A Server
Example Profile Setup String:
AT+LCPRFL=1,1,atd#777,[email protected],vzw,0,1,209.42.39.164,80
This will set up profile number 1 with
MIP Only
, packet data (username:
and password: vzw) and a TCP data transport. Further, this
particular session will sit online and function as a TCP server listening for a connection
from: 209.42.39.164 on port 80.
7.2 ATD
n
Connection String
The ATD[n] command will initiate a one-time connection utilizing the settings in the
referenced profile. ATD1 connects using profile #1, ATD2 connects using profile #3, etc.
ATD*
<IP> will initiate an online session utilizing the same settings as
AT+LCGASC=1
and then connect to the IP address listed after the asterisk.
Default:
N/A
Storage:
N/A
Command values:
ATD
<profile number> To connect just this one session. Will not redial
if connection is lost or if DTR causes a disconnection.
ATD*
<IP>
Connects to the IP address specified. Connects
utilizing the same method as
AT+LCGASC=1
.
7.3 AT+LCGASC Enable 1xRTT Auto-Session Connect
Enables or disables automatic connection and log-in to the 1xRTT network.
Default:
0
