Basic configuration
|
|
LANCOM Office
|
26
EN
If the setup wizard does not start automatically, start a manual search for
new devices in the network (
Device
/
Find
).
This input window appears only, when no DHCP server is active in your
network and your PC has also got no manually assigned IP address. Oth-
erwise the wizard goes on as described under
b
for the input 'I wish to
define the settings myself'.
Make your selection after the following considerations:
Select ’All settings to be defined automatically’ …
… if you are
not
familiar with networks and IP addresses and you have
not been used any IP addresses in your network so far. Then the router as
DHCP server will automatically specify and assign the IP addresses for all
devices in the LAN.
Select ’I wish to define the settings myself’ …
… if you are familiar with networks and IP addresses, and one of the fol-
lowing conditions is applicable:
•
You have not yet used IP addresses in your network but would like to
do so now. You would like to specify the IP address for your router,
selecting it from the address range reserved for private use, e.g.
'10.0.0.1' with the netmask '255.255.255.0'. At the same time you will
set the address range that the DHCP server uses for the other devices
in the network (provided that the DHCP server is switched on).
•
You have previously used IP addresses for the computers in your LAN.
Summary of Contents for Office Series
Page 1: ...LANCOM TM Office series...
Page 47: ...Providing dial up access 47 LANCOM Office EN...
Page 60: ...Technical data LANCOM Office 60 EN...
Page 62: ...Annex LANCOM Office 62 EN...
