Introducing the LANCOM Office
|
|
LANCOM Office
|
20
EN
1
On/off switch
2
Connection for the power adapter
Only use the included power supply unit! Using an unsuitable power supply
may cause damage or injury.
3
Reset switch – For setting the device into the delivery state, push the set
reset bottom and press it for approximately 5 seconds. As soon as the
reset switch is released, the front panel LEDs of the device will light up
and the device will be reset to the factory-default state.
4
10/100Base-Tx for the connection to the LAN. Supported are 10 Mbps or
100 Mbps connections.
LANCOM Office
identifies automatically the used
network speed (autosensing).
5
Node/Hub switch – for a direct connection of a single PC, the Rx and Tx
wires of the LAN connector
4
can be crossed within the device (’hub’ set-
ting).
When you connect to an external hub or switch, it should be set to the
’Node’ position (presetting).
6
V.24 serial configuration port
7
ISDN S
0
port
8
10Base-T-port for DSL or cable modem (not
LANCOM 800 Office
)
8
5
4
3
2
1
6
7
Summary of Contents for Office Series
Page 1: ...LANCOM TM Office series...
Page 47: ...Providing dial up access 47 LANCOM Office EN...
Page 60: ...Technical data LANCOM Office 60 EN...
Page 62: ...Annex LANCOM Office 62 EN...
