LANCOM GS
-
1224
쮿
Chapter 2: Installation
11
EN
Please be aware that LANmonitor shows far more information about
the status of the LANCOM Switch than the LEDs '
→
Monitoring the
LANCOM switch with LANmonitor'.
2.3.1
Connectors, LEDs and buttons on the LANCOM GS-1224
Located on the front of the device are connectors for different cabletypes,
light-emitting diodes (LEDs) that provide information on device status, and
also a button.
쐃
POWER LED
Constant green when power is supplied to the device.
쐇
LINK / ACT LED
Port 1 to 24
쮿
Constant green when the network connection is established to the con-
nected device.
쮿
Blinks during data transfer.
쮿
Off if no network connection can be established to the connected device.
쐋
10/100/1000
Mbps LED
쮿
Constant green when the 1000 Mbps mode is active.
쮿
Constant orange when the 100 Mbps mode is active.
쮿
Off when the 10 Mbps is active.
쐏
SFP (LINK/ACT)
LED
쮿
Constant green when the network connection is established to the con-
nected device.
쮿
Blinks during data transfer.
쮿
Off if no network connection can be established to the connected device.
쐄
Reset
Button to reset the system. If you press the button longer than three seconds,
all settings will be reset to default (factory setting).
The device starts after the reset in an unconfigured mode and
all
set-
tings will get lost. Therefore you should save the actual configuration
before
you reset the device!
쐂
TP connectors
Connectors for twisted-pair cables.
쐆
SFP connec-
tors
Connectors for small form-factor pluggable (SFP) modules.
쐃 쐇 쐋 쐏 ���
���
���