MOUNTING INSTRUCTIONS
Important
Antenna gain and terminating unused antenna connectors on the access point
It is essential for unused antenna connectors on the access point to be terminated with the supplied
rod antenna. The terminating resistor supplied with the adapter AirLancer AN-RPSMA-NJ is suitable
for use with indoor access points. In addition, you must disable the unused antenna connectors in
LCOS (changing the antenna grouping of the respective WLAN module), and configure the antenna
gain of the antenna. The settings can be found in LANconfig at:
Configuration > Wireless LAN > General > Physical WLAN settings > Radio
Operating mode
4x4 MIMO
In the 4x4 MIMO operating mode, all four antenna connectors are connected to the same WLAN
module of the access point.
Operating mode
2x2 MIMO & 2x2 MIMO
Apart from its standard operation as a 4x4 MIMO antenna, this antenna can also be used by two
different WLAN modules. For this purpose one set of the connectors marked with -45° and +45°
are connected with the each WLAN module. The two WLAN modules should not be operated in the
same frequency band.
Surge Arrester AirLancer SN-ANT
(not included)
WLAN 1
5 GHz
2x2 MIMO
Ant 1
WLAN 1
5 GHz
2x2 MIMO
Ant 2
WLAN 2
2,4 GHz
2x2 MIMO
Ant 1
WLAN 2
2,4 GHz
2x2 MIMO
Ant 2
