LANCOM 7100 VPN – LANCOM 9100 VPN
Chapter 2: Installation
20
EN
Reset button
This option controls the behavior of the reset button when it is pressed:
Ignore: The button is ignored.
Boot only: With a suitable setting, the behavior of the reset button can
be controlled; the button is then ignored or a press of the button
prompts a re-start only, however long it is held down.
Reset-or-boot (standard setting): Press the button briefly to re-start
the device. Pressing the button for 5 seconds or longer restarts the
device and resets the configuration to its factory settings.
All LEDs on the device light up continuously.
Once the switch is released the device will restart with the restored
factory settings.
After resetting, the device starts completely unconfigured and
all
set-
tings are lost. If possible be sure to backup the current device config-
uration
before
resetting.
2.3.2
Rear panel
The following connectors are located on the rear of the device.
Please observe the following notice:
The settings 'Ignore' or 'Boot only' makes it
impossible to reset the configuration to the factory settings. If the password is lost for
a device with this setting, there is no way to access the configuration! In this case the
serial communications interface can be used to upload a new firmware version to the
device—this resets the device to its factory settings, which results in the deletion of the
former configuration. Instructions on firmware uploads via the serial configuration
interface are available in the LCOS reference manual.
씉
씊
