LANCOM 1722 VoIP – LANCOM 1723 VoIP – LANCOM 1724 VoIP – LANCOM 1823 VoIP
Chapter 2: Installation
40
EN
Analog (
⌧
)
Connection status at the analog exchange line:
ETH
LAN connector status in the integrated switch:
WLAN link
Provides information about the WLAN connections via the internal WLAN
modules. The following can be displayed for WLAN link:
Orange
On (permanently)
Handset off-hook.
Orange /
red
Blinking
Hardware error
Red
On (permanently)
Calibration interrupted or temporary error (e.g. in case of
shutdown due to temperature)
Off
Interface switched off.
Green
On (permanently)
Analog exchange line is switched on.
Orange
Blinking
Call being established from exchange towards LANCOM.
The line is "ringing" at the LANCOM.
Orange
On (permanently)
The LANCOM has an analog connection—the handset of
an analog device is off-hook.
Orange /
red
Blinking
Hardware error
Red
On (permanently)
No line voltage available (cable may be interrupted)
Off
No networking device attached
Green
On (perma-
nently)
Connection to network device operational, not data traffic
Green
Flickering
Data traffic
Red
Flickering
Data packet collision
Off
No WLAN network defined or WLAN module deacti-
vated. The WLAN module is not transmitting beacons.
Green
At least one WLAN network is defined and WLAN mod-
ule activated. The WLAN module is transmitting bea-
cons.
Green
Inverse flashing
Number of flashes = number of connected WLAN sta-
tions and P2P wireless connections, followed by a pause
(default).
Alternatively, the frequency of the flashed can indicate
the input sensitivity.
