6.12
Erratic Ratio
o
Brix.
A. Incoming water and/or syrup
A. Check incoming water and
supply not at sufficient
syrup supply to ensure sufficient
flowing pressure.
flowing pressure.
B. Foreign debris in water and/or B. Remove flow controls and clean
syrup flow controls.
out any foreign materials to ensure
smooth free piston movement.
6.13
No product dispensed.
A. Water and syrup shutoffs are
A. Check stems on mounting block
not fully OPEN.
to ensure they are in fully OPEN
position.
B. Ensure cup lever arm, or I.D.
B. If not, repair or replace.
Panel actuator is actuating
switch.
C. Electric current not reaching
C. Check electric current supplied to
valve.
valve. See SPECIFICATIONS. If
current is adequate, check
solenoid coil and switch. Replace
if necessary.
D. Improper or inadequate water
D. Remove valve from mounting block
or syrup supply.
and open stems slightly and
check to ensure proper water and
syrup supply. If no supply, check
dispenser for freeze-up or other
problems.
E. BIB empty.
E. Replace BIB.
6.14
Water only dispensed,
A. Water or syrup stem on
A. Check stems on mounting
no syrup; or syrup only
mounting block not fully
block to ensure they are in full
dispensed, no water.
OPEN.
OPEN position.
B. Improper or inadequate water
B. Remove valve from mounting block
or syrup supply.
and open stem slightly to check
for proper syrup and water supply.
If no supply, check dispenser for
freeze-up or other problems.
6.15
Valve will not shut OFF.
A. Cup Lever may be sticking
A. Correct or replace lever.
or binding.
B. Switch not actuating properly.
B. Check switch for free actuation.
C. Solenoid armature not
C. Replace defective solenoid
returning to bottom position.
armature or spring.
D. Debris or damage to Paddle
D. Remove debris and/or replace
arms.
damaged paddle arms.
6.16
Excessive foaming.
A. Incoming water or syrup
A. Correct at dispenser.
temperature too high.
B. Water flow rate too high.
B. Readjust and reset
o
Brix. See
Section 5.5.
C. Nozzle and diffuser not clean.
C. Remove and clean.
D. Nozzle and diffuser not
D. Remove and install properly.
properly installed.
E. CO
2
pressure too high.
E. Check for proper pressure setting.
NOTES:
TROUBLE
CAUSE
REMEDY
7
