7. Once new product bag is connected, go back to the Main
Menu screen and press the Replace Product button.
8. From here you can prime the product pump line simply by
pressing the number of the product line that you have just
replaced.
9. Repeat Steps 4-9 for any other empty product bags there
may be.
Make sure there is an empty Jar in the Blend Station
before priming the product pump lines.
NOTE
MENU
Replace
Inventory
Fault History
Cleaning
About
Back
Home
Calibrate
Product
Manual
Controls
Machine
Lockout
REPLACE PRODUCT
Product 2
Product 1
Product 6
Product 5
Product 3
Product 7
Product 8
Back
Home
Product 4
Main Menu
Replace bag then press product button.
General Information
CLEANING AND SANITIZING
•
Lancer equipment (new or reconditioned) is shipped from the factory cleaned and sanitized in accordance with NSF guidelines.
The operator of the equipment must provide continuous maintenance as required by this manual and/or state and local health
department guidelines to ensure proper operation and sanitation requirements are maintained.
The cleaning procedures provided herein pertain to the Lancer equipment identified by this manual. If other
equipment is being cleaned, follow the guidelines established by the manufacturer for that equipment.
• Use sanitary gloves when cleaning the unit and observe all applicable safety precautions.
• DO NOT use a water jet to clean or sanitize the unit.
• DO NOT disconnect water lines when cleaning and sanitizing syrup lines, to avoid contamination.
• DO NOT use strong bleaches or detergents; These can discolor and corrode various materials.
• DO NOT use metal scrapers, sharp objects, steel wool, scouring pads, abrasives, or solvents on the dispenser.
• DO NOT use hot water above 140° F (60° C). This can damage the dispenser.
• DO NOT spill sanitizing solution on any circuit boards. Insure all sanitizing solution is removed from the system.
DO NOT attempt to perform repairs. Never remove the side or back panels on the unit. The unit does not contain
adjustable or customer servicable parts. The manufacturer or an authorized agent must perform all interior service
and adjustments. Removing panels or attempting to perform repairs without authorization will void the warranty.
NOTE
NOTE
•
Cleaning should be accomplished only by trained personnel. Sanitary gloves are to be used during cleaning operations.
Applicable safety precautions must be observed. Instruction warnings on the product being used must be followed.
!
ATTENTION
!
ATTENTION
12
