PAGE 10
Do not plug the transformer into the receptacle yet. Make sure inlet and outlet valves are to their closed positions. If using
optional bypass, open bypass valve. Turn on main water supply. Open a cold water faucet. This will clear the line of any
debris (solder, pipe dope, etc.) that may be in the line. Let water run at faucet for a couple minutes, or until clear. Turn off
faucet. Now plug the transformer into a 120 volt receptacle (be certain the receptacle is uninterrupted). Within 5 seconds
the control display and buttons will illuminate and the time of day screen will appear.
•
Press and hold the
REGEN
button for approximately 5 seconds until the motor starts.
•
Wait until display reads
BACKWASH
and numbers start counting down.
SLOWLY
open inlet valve to
DIAGNOSTIC
mode (
See page 5
) to allow water to slowly fill Filter and expel air. CAUTION:
If water flows too rapidly, there could be a loss of mineral out of the drain.
When water is flowing steadily to drain without the presence of air, momentarily press
REGEN
again. Display will read
RINSE
. Close the bypass valve and open the outlet valve of the filter, for
NORMAL OPERATION
(
see page 5
). Allow
control to finish the
RINSE
cycle. Allow the control to automatically advance to the
FILTERING
position.
PLACING FILTER INTO SERVICE
GENERAL OPERATION
User Displays
When the system is in normal service mode, one of up to five
available User Displays will be shown. Pressing
NEXT
will
alternate between the following displays:
• Current time of day
• Treated water flow rate (if optional meter is used)
• Service contact name and phone number (if entered)
• Remaining Capacity of treated water available (if optional
meter is used)
• Remaining days to backwash (if Day Override is
programmed)
Pressing the
button while in the Capacity Remaining or
Days Remaining displays will decrease the capacity remaining
in ten gallon increments or the days remaining in one day
increments.
To clear the Service Call reminder
, press the
and
buttons simultaneously while the number and banner text
screen is displayed.
If the system has called for a backwash that will occur at
the preset time of backwash, the words REGEN TODAY will
alternate with the header on the display.
Utilizing the control valve’s optional water meter, a water drop
flashes on the display when water is being treated (i.e. water is
flowing through the system).
Drop will flash while water
is being treated. Optional
meter required.
NEXT
NEXT
NEXT
Contact Screen
NEXT
Note: As an energy saving feature, the control will automatically turn off all SOLID BLUE or SOLID GREEN display
illumination and keypad illumination after about 5 minutes of the last keypad button push. Any further keypad touch will
cause the re-illumination of the display and keypad, and re-activate keypad control.
Summary of Contents for X FACTOR LX15 Series
Page 31: ...PAGE 31 NOTES ...
