10
/ 56 English
EN
FR NL
Écran LCD
insert_photo
3
1 Timer
2 Clock indicator: flashes dur-
ing electro-stimulation
3 EMS mode
4 Intensity of channel 1
5 Channel 1 symbol
6 Chanel 1 electrodes indicator :
flashes if the channel 1 electrodes
are incorrectly positioned
7 Programme number
8 TENS mode
9 Intensity of channel 2
10 Channel 2 symbol
11 Chanel 2 electrodes indicator :
flashes if the channel 2 electrodes
are incorrectly positioned
12 Battery indicator: flashes when the
batteries need to be replaced
INSTRUCTIONS FOR USE
Batteries
Insertion
The Medi Stim runs on 3 AAA 1.5V batteries
(not supplied) Before using your device, in-
sert them correctly into the compartment
provided
[
insert_photo
4]
.
1 Remove the cover of the battery
compartment of the device.
2 Insert 3 AAA 1.5 batteries (not
supplied) into the compartment,
making sure they are installed cor-
rectly using the polarity symbols.
3 Firmly close the compartment again.
Checking and replacing the batteries
The batteries will need to be replaced after a
certain length of time in order to ensure the
device continues to run safely. The battery in-
dicator on the screen will flash when the power
supply is too low
[
insert_photo
3
label
12]
.
Electrodes
Connecting the electrodes
to the cables
Before switching on your device, connect the
power supply cable to the electrodes. Insert
the connector cable into the electrode’s con-
nector. Make sure they are connected correctly
in order to ensure the device performs well by
referring to
[
insert_photo
5]
.
Connection to the device’s cables
The cables can only be connected when the
device is switched off. Insert the cables into
the jacks located on the top of the device
[
insert_photo
2]
. There our two output channels: you can
choose to use one or two of them. Using both
of them means that you can stimulate two ar-
eas at the same time.
Replacing them
The electrodes are intended to be used up to
30 times. Order new electrodes from the same
supplier as the device or one of its distributors
in order to ensure quality.
Positioning them
Remove the protective film and keep it. Do not
put the electrodes on irritated or damaged
skin. You should also check that your skin is
clean and dry.
Stick the patches on firmly and make sure that
there is sufficient contact between the skin
and the electrodes.
To obtain the desired effect from stimulation, it
is important that the electrodes are positioned
carefully. We would advise you to define the
best positions of the electrodes in the area
E-IM-MediStim-001.indd 10
19/12/2017 14:45:35
