EN
Air jets
500W
Power cable
4.5 m
Filter pump
AC 12V/60W
2300L/H
Heat rate
+/- 2°C/Hr (+/- 4°F/Hr)
Maximum temperature
40°C (104°F)
Weight when full
828 kg
INSTALLATION INSTRUCTIONS
Description of components (
diagram 1
) :
A: PVC safety cover
B: Pump
C: Spa bath
D: Safety lock
E: Inflation hose
F: Hose connector
G: Water inlet and outlet adaptors
H: Drainage outlet hose
I: Repair kit
J: Filter
K: Drainage adaptor
L: Drainage valve
LOCATION OF INSTALLATION SITE
Due to the combined weight of the spa bath, the water, and the users, it is extremely important that the tub be installed
on a smooth, level surface, able to support the weight evenly. If the spa bath is positioned on a surface which does not
meet these criteria, any damage caused will not be covered by the warranty. It is the responsibility of the spa bath owner
to ensure the suitability of the site at all times.
A. INDOOR INSTALLATION
To install your spa bath indoors, please adhere to the specific requirements below:
• The surface must be able to support the weight of the spa bath and its contents.
• Pay particular attention to the floor underneath the spa bath. Select a surface which will not be damaged or stained.
• The surface must be level and not slippery.
• Proper drainage is essential for all interior installation. If you are constructing a new room for your spa bath, a floor
drain is recommended.
• A spa bath naturally produces humidity. Consider the effects of air moisture on any wood, paper etc in the proposed
location. To minimise these effects, ensure that a means of ventilation is available in the area chosen. An architect can
advise you whether additional ventilation is required.
NOTE:
Do not position the spa bath on carpet or any other material which could be damaged by moisture.
8