Lamtec F152, Manual

Page: 31 / 66

30
5 Commissioning
5.3 Putting the Device into Operation for the First Time
5.3.1 Requirements
Prerequisites for putting the device into operation for the first time: :
• The F152 and the respective flame scanner must be mounted as specified in chapter 5.2
Setup .
• The flame scanner must be aligned as specified in 5.3.2 Adjustment and Positioning .
• All electrical installations must have been tested.
• All terminal and plug-in connections must have been tested.
NOTICE
Putting the device into operation

To operate the Flame scanner safely, you have to adhere to the following sequence when
putting it into operation for the first time:
NOTICE
Flame intensity indication F152

If no load is connected to the current loop terminal X14/3,4, it is necessary to insert a wire
bridge at the terminals on F152. Otherwise the flame intensity will not be displayed on the
F152.
5.3.2 Adjustment and Positioning
WARNING!
Checking the switch-off parameters
There is a risk of death and serious injury.

The switch-off parameters are to be verified through switch-off tests, see chapter 5.3.5
Switch-off Test . Changes made to settings (increase or weighting of doublesensor) do af-
fect the switcht-off parameters and therefore new switch-off tests are to be carried out.
NOTICE
Reliable detection of the flame
Warning to avoid damage to property

Set the parameters in such a way that, across the entire performance range and in all of
the combustion's modes, safe detection of "flame OFF" and stable detection of "flame ON"
are ensured.