5
Always, use Male XLR 3 or 5 pin connector to connect the projectors to the DMX controller.
Solder on PIN 1 of the XLR connector the shield of the signal cable, on PIN 2 solder the negative (example: black wire of
cable) and on PIN 3 solder the positive (example: red or white wire of the cable). The sequences and the colours has to be the
same on the terminal connection blocks, do not change the sequences.
Power supply connection
It is advised to check the electric system before installation. From 85Vac to 265Vac (50 o 60 Hz).
Disconnect mains power supply before any operations.
Connect the fixture to the mains. See the table and the drawing for the colours of the connection cable.
Do not power the projector with a dimmer circuit
Protect the electric system with highly sensitive differential circuit breaker, 30mA.
When in doubt, consult a qualified electrician.
The projector is complete grounded, it is necessary to connect at grounding system.
The power unit has
Weiland
panel connector, male connector is included.
DMX signal cable connection
Projector has XLR 3pin panel connectors, complete the connection
with compatible standard cable with plug for DMX signal.
Pin 1: GND, shield
Pin2 : signal –
Pin3 :
