3
Installation
The projector can be installed and work in any position, use diameter 10mm holes of the bracket to fix the projector or use the
double bracket to install on ground.
Unscrew the side knob to adjust the projector body angle.
With suspension projector, we suggest to install a supplementary safety steel chain or cable
Display interface and connectors there are on rear of projector.
In front of the projector there are a slots for accessory, it is possible to mounting frontal glass, diffuser or other …….
Example of installation
If only one projector is on stand alone mode the signal cable is not necessary.
If the projectors are driven by a DMX controller or projector Master drive other projectors Slave, they need to be connected
together, with DMX signal cable, following the instructions of this manual.
The DMX signal is generated by a DMX controller, the signal cable goes in and out from each projector up to the last one.
The projectors will execute the same scenes if the DMX addresses are the same (factory set is 1) or they can be driven one by
one if the DMX addresses are different from each other.
Default mode
7C d
: each projector uses 8 DMX channels
Projector 1: DMX address 1
Projector 2: DMX address 9
Projector 3: DMX address 17………….
If the DMX controller is not switched on, the projectors can be in black-out mode, generate light at 15% (default setting) or
generate light at 100%. Change this parameter at – DM.DE of menu.
It is possible to use MASTER/SLAVE function: One projector (Master) functioning in stand alone mode with resident
programs and a group of projector (Slave) execute, thanks to dmx signal and signal cables, the same sequences of colours.
The projectors can be fed from different power sources, it is not necessary to switch on the projectors at the same time.
