3
HANGING DOOR AND ADJUSTMENT
2
Floor Guide(
④
or
⑩
)
2. Top Part
Insert the upper roller into the holder as shown in the drawing below.
※
Bind head tapping
screw 4
×
16
1. Bottom Part
,QVHUWWKHÀRRUJXLGH6LQWKHJURRYH
and then hang the door in the bracket.
2. Installing Bracket
Remove Bracket and Holder from Upper roller.
Mount the Bracket with attached screws.
Tapping screw
4×16(not provided)
Correct set position
Trigger catcher
Correct set position
If the closer is installed without conformation,
it will cause the trouble such as no-sliding of door.
ϕ
6
If the position is wrong, pull back the trigger catcher to
the correct position using 6mm diameter hard bar.
In
correct set position
OK
272
Leading edge
Trailing edge
⑤
Upper trac
k
③
Upper roller
①
Two-way
soft closer
❶
❷
Door (tail end)
32
※
Pay attention on setting direction of the bracket.
Opening part of the bracket should face to outside direction.
3. Installation of Door Bottom Guide Track
Fix door bottom guide track with the recommended
VFUHZV¿UPO\
⑥
D o o r b o t t o m g u i d e
track(for dimensions, refer to
“INSTALLATION DRAWING”)
①
Two-way
soft closer
③
Upper roller
Leading edge
Trailing edge
Leading edge : The
leading edge of the
track has two 5 mm
dia. holes at 272 mm
position from the end.
Refer to “Installation Drawing
(Example)”
Floor Guide(
④
or
⑩
)
⑤
Upper track
Upper roller
Bracket
80
25
80
6
72
110
25
12
12
25
①、③
screw
4×45
Outside
Outside
Bracket
Holder
Upper roller
Remove
&RQ¿UDWLRQ%HIRUH,QVWDOOLQJWKH7ZRZD\6RIW&ORVHU
5. Assembly of Parts For Track
(1) Assemble the parts in order of
❶
to
❷
with care of direction.
(2) Tape around rollers and upper track to prevent drop of
inserted parts.
6. Mounting Upper Track
&RQ¿UPWKDWOHDGLQJHGJHRIWKHXSSHUWUDFN
is in same direction as the leading edge of
the door. Fix the upper track with attached
Screws 5×40.
7. Mounting Trigger
According to “Installation Drawing (Example)”,
install triggers with attached Screws 4×16D6.
8. Mounting Floor Guides
Install the floor guide so that it remains between
the leading and trailing edges of the door when it is
opened or closed.
3. Remove the jig.
2. Install trigger.
1. Align trigger and
mounting jig with
mount hole.
②
Trigger
Leading edge
②
Trigger
Screw
4×30(
Φ
6head)
Trigger mount hole
Trigger mounting jig
90°
Trigger
Mounting
screws
90°
Out of the straight
Correct installation
Out of straight
Correct installation
272mm
DW-473mm
