7
補足3
Trigger positions
Door must be stopped by
bumper block and door stopper.
Crimped trigger
Trigger
Retrofit Trigger
⑪
Bumper block
(Sold separately)
⑪
Bumper block
(Sold separately)
147
297
[299]
Door width
- 297
[Door width - 299]
147
[149]
Door width
Available opening width
Door width
Available opening width
Reference line for trailing edge
(Trailing edge when the door is opened)
Reference line for leading edge
(Leading edge when the door is closed)
Leading edge when the door is fully opened
Trigger
297
[299]
Door width-297
[Door width-299]
Door must be stopped by
bumper block and door stopper.
⑨
Door stopper (floor)
(Sold separately)
⑨
Door stopper (floor)
(Sold separately)
Standard installation
Upper track installed inside door jamb
Special fit
(e.g.) No vertical frame and
stop with door stopper and
bumper block
Leading edge when the door is fully opened
※
4
PERIODICAL
INSPECTION
・
Clean the inside of the track.
・
Check the upper and lower space of the door. If necessary, correct the space.
TROUBLESHOOTING
Trouble
Checkpoint
Solution
Door stops during soft
closing.
Check if door bottom contacts the floor or floor guide. Verify that track mounting screws are not loosened. Then, adjust door height
such that the clearance between the door bottom and floor is 7 - 13 mm.
Check if the upper track is set horizontally.
Using a level gauge, reset the upper track horizontally.
Check if mohair seal is installed.
Reduce the friction between the mohair seal and door.
The door doesn
ʼt close softly. Check if trigger is installed.
Install trigger to specified position.
Check if door is closed by excessive force.
Do not close door by excessive force as it may damage the soft closer.
The position of the trigger catcher in page 3 section
3
may become dislocated (It is hidden as installed in
upper track.)
Slowly move the door towards the leading edge, then push the door firmly.
Repeat this action on the opposite side as well.
If it is still not improved, check the status of the trigger catcher in section
3
.
Abnormal noise during
operation
Check if door bottom contacts the floor or floor guide. Verify that track mounting screws are not loosened. Then, adjust door height
such that the clearance between the door bottom and floor is 7 - 13 mm.
Check if door touches adjacent parts.
Adjust the door depth position to avoid contact with other objects or adjust the
position of floor guide.
Check track rollers for aluminum dust.
Remove the track
,
then pull out and clean the roller.
Check the track mounting screws for looseness.
Retighten the screws to free the roller.
Heavy door operation
Check if door bottom contacts the floor or floor guide. Verify that track mounting screws are not loosened. Then, adjust door height
such that the clearance between the door bottom and floor is 7 - 13 mm.
Check if door touches adjacent parts.
Adjust the door depth position to avoid contact with other objects or adjust the
position of floor guide.
The position of the trigger catcher in page 3 section
3
may become dislocated (It is hidden as installed in
upper track.)
Slowly move the door towards the leading edge, then push the door firmly.
Repeat this action on the opposite side as well.
If it is still not improved, check the status of the trigger catcher in section
3
.
Door does not move.
Check the track retaining screws for looseness.
Retighten the screws to free the roller.
[ ] : When cover cap
⑧
(option) is used.
※
4
Determine the trigger position by the reference line for the leading edge at fully opened
position even when a margin is set.
Appendix 3
