15/EN
5
Maintenance and care
General information
Service life of the product will extend and
frequent problems will decrease if the product
is cleaned at regular intervals.
Disconnect the product from mains
supply before starting maintenance
and cleaning works. There is the risk of
electric shock!
Allow the product to cool down before
you clean it. Hot surfaces may cause
burns!
•
Clean the product thoroughly after each
use. In this way it will be possible to
remove cooking residues more easily,
thus avoiding these from burning the
next time the appliance is used.
•
No special cleaning agents are required
for cleaning the product. Use warm water
with washing liquid, a soft cloth or
sponge to clean the product and wipe it
with a dry cloth.
•
Ensure that all residual fluids are
removed after cleaning and also ensure
that food materials splattered during
cooking are cleaned immediately.
•
Do not use cleaning agents that contain
acid or chloride to clean the stainless or
inox surfaces. Use a soft cloth with a
liquid detergent (not abrasive) to wipe
those parts clean, paying attention to
sweep in one direction.
The surface might get damaged by
some detergents or cleaning materials.
Do not use aggressive detergents,
cleaning powders/creams or any sharp
objects during cleaning.
Do not use steam cleaners for
cleaning.
Metallic surfaces
Lime, grease, starch and protein stains
should be removed immediately. Such stains
can cause corrosion beneath.
Products with inox surfaces
Use a mild glass cleaning agent and a soft
glass cleaning cloth or a lint-free microfiber
cloth. Clean the surface without applying too
much pressure and in vertical direction.
Heating plate
Clean the heating plate with hot water and a
little amount of detergent.
Removing the Drawer
You can remove the drawer to clean the
interior of the drawer.
1. Fully take out the drawer.
2. Remove the 2 screws on the front section.
3. Hold the drawer from front right and left
positions and lift approx. 5° upwards.
1
Drawer
2
Screw
4. Carefully pull the drawer towards yourself
and place aside. Clean the interior of the
product with a damp cloth and detergent
and wipe it dry.
Never submerge the drawer into water.
Installing the Drawer
Follow the above steps in reverse order to
install back the drawer.
Place the drawer on the racks. Pull the right
and left side racks to front, until the screws
are located in the holes. Secure the screws.
Summary of Contents for LAM9004
