Lamona LAM9004, Instructions And Installation

Page: 14 / 20

12/EN
Electrical Electrical connection
Connect the product to a grounded outlet/line
protected by a miniature circuit breaker of
suitable capacity as stated in the "Technical
specifications" table. Have the grounding
installation made by a qualified electrician
while using the product with or without a
transformer. Our company shall not be liable
for any damages that will arise due to using
the product without a grounding installation in
accordance with the local regulations.
DANGER:
The product must be connected to the
mains supply only by an authorised
and qualified person. Manufacturer
shall not be held responsible for
damages arising from procedures
carried out by unauthorised persons.
DANGER:
The power cable must not be clamped,
bent or trapped or come into contact
with hot parts of the product.
A damaged power cable must be
replaced by a qualified electrician.
Otherwise, there is risk of electric
shock, short circuit or fire!
• Connection must comply with national
regulations.
• The mains supply data must correspond
to the data specified on the type label of
the product
. You can see the type label
on the top surface of the product.
• Power cable of your product must comply
with the values in "Technical
specifications" table.
DANGER:
Before starting any work on the
electrical installation, disconnect the
product from the mains supply.
There is the risk of electric shock!
Connecting the power cable
1. This product must only be connected by a
suitably qualified person to a suitable
double-pole control unit with a minimum
contact clearance of 3 mm in all poles.
This control unit must be installed
accordance with the IEE regulation.
Failure to obey this instruction may cause
operational problems and invalidate the
product warranty.
Additional protection by a residual current
circuit breaker is recommended.
If a cable is supplied with the product:
2. For single-phase connection, connect the
wires as identified below:
• Brown/Black cable = L (Phase)
• Blue/Grey cable = N (Neutral)
• Green/yellow cable = (E) (Ground)
» or
•
Grey/Black cable = L (Phase)
• Blue/Brown cable = N (Neutral)
• Green/yellow cable = (E) (Ground)
Installing the product
Final check
1. Plug in the power cable and switch on the
electrical fuse of the home.
2. Check to see if the product is operational
or not.