Lamona LAM9004, Instructions And Installation

Page: 10 / 20

8/EN
3 Installation
Product must be installed by a qualified
person in accordance with the regulations in
force. Otherwise, the warranty shall become
void. Manufacturer shall not be held
responsible for damages arising from
procedures carried out by unauthorized
persons, and the product's warranty shall
become invalid.
The customer is responsible for the
preparation of the location at which the
oven will be installed and the
necessary electrical wiring.
CAUTION:
The product must be installed in
accordance with all local electrical
regulations.
CAUTION :
Prior to installation, visually check if
the product has any defects on it.
If so, do not have it installed. Damaged
products cause risks for your safety.
Appropriate installation location
This product is designed to be installed into
commercially available kitchen furniture. A
safety distance must be left between the
appliance and the kitchen walls and furniture.
See figure (values in mm).
•
Surfaces, synthetic laminates and
adhesives used must be heat resistant
(minimum 100°C).
• Remove the packaging material and
transport locks.
Do not install the product next to
refrigerators or freezers. The heat
emitted by the product will increase the
energy consumption of cooling
appliances.
Do not use the door and/or handle to
carry or move the product.
Drawer Frontal Alignment
To adjust VERTICAL alignment of drawer
frontal, slacken off 4 screws on near of frontal
and retighten when in designal position.