11
CLEANING AND MAINTENANCE
Cleaning is the only maintenance action
that is required normally.
WARNING!
Cleaning must be done with the
Warming Drawer disconnected from the
electrical power supply. Remove the plug
from the power socket or disconnect the
Warming Drawer power supply circuit.
Do not use aggressive or abrasive
cleaning products, abrasive sponges or
pointed objects since stains or abrasion
marks may appear.
Do not use high pressure or steam jet
cleaning appliances.
APPLIANCE FRONT AND
CONTROL PANEL
The Warming Drawer can be cleaned
using just a damp cloth. If it is very dirty,
add a few drops of washing-up liquid to
the washing water.
Wipe the surfaces dry using a dry cloth.
For stainless steel fronted Warming
Drawers, special products for treatment
of stainless steel surfaces can be used.
These products prevent the surfaces
becoming dirty again for some time.
Apply a thin layer of such a product on
the surface using a soft cloth.
On aluminium fronted Warming Drawers
use a gentle glass cleaning product and
a soft cloth that does not release fluff.
Wipe horizontally without pressing on the
surface since aluminium is sensitive to
scratches and cuts.
INTERIOR OF THE WARMING
DRAWER
Clean the inside of the Warming Drawer
regularly using a damp cloth. If it is very
dirty add a few drops of washing-up
liquid to the washing water.
Wipe the surfaces dry using a dry cloth.
Avoid water entering through the air
circulation opening.
Only use the Warming Drawer again
when it is completely dry.
ANTI-SLIP MAT
The anti-slip surface mat can be
removed to facilitate cleaning of the
drawer.
The mat can be cleaned by hand using
hot water with a few drops of washing-up
liquid. Dry thoroughly.
The anti-slip mat should only be replaced
when it is completely dry.
