DIMENSIONS AND CLEARANCES
Worktop cutout sizes
Hobs - 53mm min
Hobs - 53mm min
X
Y
rear wall
Please see table below for hob cut out dimensions for your appliance
Product
X(mm)
Y(mm)
*60cm hob
560
490
*
77cm hob
737.5
487.5
*
The nominal dimensions are shown on the hob cut out table and must be fabricated to a toler-
ance of +2.0mm -0.0mm with maximum corner radi of 4.0mm
Fitting into work top
Sufficient length of cable should be allowed so the hob can be removed for servicing, but make sure it
is routed away from the underside of the hob & does not get trapped during installation.
Important:
Ensure that you route all electrical cables and flexible tubing well clear of any adjacent heat
source - eg; oven / grill.
Protecting the cut-out;
The types of chipboard used for work surfaces swell relatively quickly in contact with humidity.
Apply a special varnish or adhesive to the cut edge to protect it from steam or condensation which may
form under the work surface under the hob.
This hob can be installed conventionally (glass above the work top) or recessed into the work top for a
flush fit.