11
• Installation
Mounting the Extractor
•
Mark, drill and the top
screws into the
adjacent wall unit side panels at 15mm from
the top and 30mm from the front of the wall
unit as shown. Leave a gap of 5 mm between
the heads of the screws and the wall unit side
to allow the extractor to be hung. The distance
between the screw and the
cooking surface should no
less than 1040mm.
•
Hang the cooker hood on
the screws between the two
cupboards.
•
Push the fan-shaped door frames fully closed, line up the door frames 2 mm
in front of, and parallel with, the front edges of the adjacent wall units (not
the doors) and mark the
positions of the lower screws.
•
Remove the extractor, drill the two lower
holes and re-hang the
extractor.
•
Ensure that the extractor is lined up correctly with the adjacent wall units,
and tighten the two lower screws and fully tighten the two top
screws.
Make sure all four screws are well
•
Connect the air-outlet board and, if the appliance is being ducted out, the
air-outlet tube.
5mm
36
0
2
15
30
