12
• Installation
Decor Door Installation
•
The door should be no less than 16 mm
thick, 385 - 700 mm high, and weigh no
more than 7 kg.
•
The door frames are located in two curved
plastic slides on each side of the extractor
body and are prevented from being pulled
out too far by plastic limit clips which are
accessible after removal of the perforated
grease
•
Take care not to drop the frame, pull lightly
on the plastic limit clips ‘1’ while opening
the door frames ‘2’. Once the door frame
has cleared the plastic clip, the door frame
can then be removed from the body of the extractor.
•
Lay the decor door face down on a protective surface, accurately mark and
pilot drill the 4
positions.
•
Check that the screws are not too long for the decor door, to prevent
damage to the door front and secure the door frames to the door, ensuring
that the frames are symetrically positioned on the decor door.
the assembly of decor door and door frames onto the extractor
ensuring that all four plastic slides are correctly located. Once the door
is fully closed, the plastic limit clips should once again prevent accidental
removal of the door frame from the appliance.
•
If the upper edge of the door is not aligned with the upper edges of the
adjacent cabinet doors adjust using the 4
screws.
•
Once aligned, secure the door in position using a further 4 screws.
21
