Lamobo R1, User Manual

Page: 16 / 28

Lamobo R1(BPI-R1) User Manual
Version 1.0
15
Step 5: Set Up Your Lamobo R1
According to the set up diagram below, you can easily set up your Lamobo R1.
1. Insert the written-image SD card that to the SD card spot on the left side
edge of the underside of the board.
2. The HDMI Type A (Full sized) port is between a USB port and a RJ45 port
of the board. Just connect any HDMI cable from the board to your TV or
HDMI Monitor.
3. Plug a mouse into the USB slot.
4. Plug a Ethernet cable into the RJ45 slot.
5. Finally, at the very left of the bottom edge is the micro-usb power
connector. Plug in a regulated power supply that is rated at 5V ± 2% and
at least 2A.
If all goes well, the R1 will boot in a few minutes. The screen will display
the OS GUI.