Lambrecht power[cube] 30.95800.015000, Manual

Page: 9 / 10

________________________________________________________________________________________________
________________________________________________________________________________________________
9
Return Wi-Fi module to factory settings
There are 2 ways to return the Wi-Fi module to factory settings:
- via software button on the configuration webpage of the Wi-Fi module
- via hardware button at the outside of the housing below the green 3-pole terminal
Factory setting via configuration webpage
If the Wi-Fi module can still be reached via the browser you can return to factory setting with the „Load
Default Button“ at the page „Device Management“ of the Wi-Fi module.
The Wi-Fi module has following default settings:
IP address: 10.10.100.254
User: admin
Password: admin
Wi-Fi name Wi-Fi module: USR-WIFI232-630_XXXX
(the name ends with the last 4 signs of the MAC address (without „:“ or „-“)
1.) Open the page „Device Management“ via the corresponding link.
2.) By pushing the „Load Default Button“ the device returns to factory settings.
Factory settings via hardware button at the outside of the housing
At the outside of the housing below the 3-pole terminal is a small hardware button. By pushing the same in
activated mode (Power LED and Ready LED ON) for at least 3 seconds the Wi-Fi module returns to factory
settings.
1.) Dismantle the Wi-Fi module from the cap rail by pushing it upwards and tilting outwards. Alternatively you
can unscrew the antenna and the 3-pole terminal to reach the hardware button.
2.) Push the hardware button in activated mode (Power LED and Ready LED ON) for at least 3 seconds.
3.) Loose the hardware button and wait 10 seconds while the Wi-Fi module is re-initialisating. The Ready