Lakeland 63480, Instruction Booklet, Page: 12 / 20

12
Note: After making steam, you can press single cup (1cup) button or double cup (2 cup)
button immediately to brew coffee again. The icon shown in the control panel is flashing
the temperature is too high, at that time, you need to reduce the temperature by following
the operation as below. Place a jug with some cold water in under the steam wand, with
the metal sleeve below the water. Turn the water/steam knob to steam/hot water position
then the hot water will dispense. After pumping water to reduce the temperature for about
10 seconds, turn the knob to “DOT” position, then you can brew coffee again. Alternatively
press the On/off button and let the appliance cool down for 5 minutes.
PRODUCING STEAM TO HEAT LIQUIDS
The steam wand can be used to froth milk singly or to make hot beverages like drinking
chocolate.
Method:
1. Remove the water tank and fill it with fresh water, the water level should not exceed the
‘MAX’ mark in the tank. Then place the water tank on to the appliance properly.
2. Plug in and switch on at the socket and press the On/off button, the control panel will
start flashing.
3. When the control panel illuminates in full, it shows the pre-heating is finished.
4. Insert the metal sleeve of the steam wand into the milk by about 2cm.
5. Press the steam button on the control panel and it will flash, when the steam button
has stopped flashing, then turn the water/steam knob anticlockwise to the steam/hot
water position, steam will come out from the steam wand. Froth the milk by moving
the jug up and down.
6. When the required amount of frothing is reached, you can turn the water/steam knob
to the “DOT” position.
Note: Clean the steam outlet with a wet sponge immediately after steam stops generating,
be carefully as this will be hot.
7. When you have finished using, press the On/off button to switch off the appliance.
8. If there becomes no power to the appliance during steam release, residual heat will
make product continue to release steam for a length of time, the product will stop
releasing steam immediately once you turn off the water/steam knob.
SET THE DISPENING AMOUNT
1. Dispensing Amount of Single Cup
Hold and press the single cup (1 cup) button for 3 seconds to enter into the mode
setting for the dispensing amount. Press the single cup (1 cup) button again, the coffee
starts to dispense and the icon flashes at the same time, when the desired amount has
been dispensed, press the single cup (1 cup) button again, the coffee stops dispensing.
At that time, the setting for the dispensing amount of single cup is finished and it will
be saved for next operation. The adjustable dispensing amount of single cup ranges
between 25ml and 50ml, the working duration for this setting is a maximum of 45 seconds.