11
1. Place the Steam Mop in an upright position, the head will lock into position so it
remains upright and then fill the water tank.
2. Plug in and switch on the Steam Mop at the socket. All the lights on the display
panel will illuminate and flash once.
3. On the display panel the on/off icon will illuminate and flash red, the appliance
is in standby mode.
4. Press the on/off button twice in quick succession on the control panel to
switch on.
5. The steam icon will illuminate red and flash until it has reached temperate, then
it will illuminate white and remain on. The Steam Mop is ready to use.
6. The default setting is ceramic tile floor (shows as tile).
7. To switch between the types of floor settings press the toggle button to cycle
through the settings, if you keep pressing the toggle button it will loop round in
a circle.
8. Take the mop by the handle and use your foot to release the head from the locked
upright position.
9. Slowly slide the Steam Mop head back and forth over the floor.
10. Never apply steam to one area for more than 10 seconds, this can damage
your floor.
11. Should you wish to enter into standby mode at any stage, press the
on/off button.
12. When the steam icon flashes white, the water tank is low or empty and needs
refilling. The appliance will automatically enter standby mode
13. Press the on/off button to turn the Steam Mop off and switch off and unplug at
the socket before refilling.
14. When you have finished cleaning the floor, turn off and unplug at the socket and
empty the water tank.
15. Never leave the Steam Mop on any surface for any period of time with a damp or
wet floor pad attached, this will damage your floors.
16. When the mop has been switched off, if stood upright water may still come from
the head. This can damage floors. Ensure any excess water is removed.
17. Wait until the appliance has fully cooled before removing the microfibre floor pad.
18. Remove the microfibre floor pad after use by simply pulling it off the head once the
appliance has fully cooled down.
