11
Its operating range covers nearly DC to 200 kHz (-3dB corner
frequency) in order to ensure optimum linearity within the audible
frequency spectrum.
Overall gain is set to +8 dB to enable the unit to drive high-Z
headphones at sufficient volume.
HEADPHONES OUTPUTS
The PHONE-AMP G100 offers two stereo headphone outputs, each
equipped with a standard 1/4" phone jack.
1/4
” Phone Jack:
TIP
Left Channel
RING
Right Channel
SLEEVE
GND
When turning the unit on or off, the outputs are cut from the remaining
circuitry by means of a relay.
Special features
Please note:
The following chapters refer to internal settings of the PHONE-AMP
G100. To alter these settings, a TORX screwdriver T10 is required. The
more, you should by all means
PULL THE MAINS CORD !!!
after which all settings can be performed without any hazard.
There's hum...
Among other reasons, hum results from equalising currents caused by
ground loops, e.g. due to the system being connected to separate mains
outlets. This can be avoided by "soft" or
“hard” grounding of the
PHONE-AMP G100: It is achieved by setting the ground lift jumper to
either the
“LIFT” or the “GND” position.
Summary of Contents for G100 Final Edition
Page 1: ...1 PHONE AMP G100 Final Edition USER s MANUAL ...
Page 14: ...14 ...
