WB50NBT
Hardware Integration Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/wi-fi
18
© Copyright 2016 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0600
Important Note:
In the event that these conditions
cannot be met
(for example certain laptop configurations or co-location with
another transmitter), then the FCC authorization is no longer considered valid and the FCC ID
cannot
be used on
the final product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
End Product Labeling
This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm
may be maintained between the antenna and users. The final end product must be labeled in a visible area with
the following for the WB50NBT:
Contains FCC ID:
SQG-WB50NBT
.
Manual Information to the End User
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove t
his RF odule i the user’s a ual of the e d produ t hi h i tegrates this odule.
The end user manual shall include all required regulatory information/warning as show in this manual.
Industry Canada
Industry Canada Statement
This device complies
with Industry Canada
’s
license-exempt RSSs.
Operation is subject to the following two
conditions:
This device may not cause interference; and
This device must accept any interference, including interference that may cause undesired operation of
the device.
Le pr
ése t appareil est o for e aux CNR d’I dustrie Ca ada appli a les aux appareils radio exe pts de li e e.
L’exploitatio est autorisée aux deux o ditio s suiva tes:
l’appareil e doit pas produire de rouillage;
l’utilisateur de l’appareil doit a epter
tout brouillage radioélectrique subi, même si le brouillage est
sus epti le d’e o pro ettre le fo tio e e t.
This radio transmitter
(WB5050NBT
–
IC: 3147A-WB50NBT
)
has been approved by Industry Canada to operate
with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with
this device.
Le présent émetteur radio
(WB5050NBT
–
IC: 3147A-WB50NBT
)
a été approuvé par Industrie Canada pour
fonctionner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types
d'antenne non inclus dans cette liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement
interdits pour l'exploitation de l'émetteur.
