Sentrius RG1xx
User Guide
Embedded Wireless Solutions Support Center:
http://ews-support.lairdtech.com
www.lairdtech.com/ramp
34
© Copyright 2017 Laird. All Rights Reserved
Americas: +1-800-492-2320
Europe: +44-1628-858-940
Hong Kong: +852 2923 0610
Use a 1.5 mm screwdriver to fix the core wire(s) into the screw fixing point (
Figure 46
).
Figure 46: Core wire fixed into the screw fixing point
Note:
The cable core wires for the power cable assembly need to be in the range
of 14 AWG to 18 AWG to fit properly in the screw points. We recommend
that you strip and tin the ends of the core cable wires to make the install
easier when inserting the wire into the screw points. Range of length
tinning wire: 5 mm
–
6 mm.
Pin 2 should be negative (black wire) and Pin 1 should be positive (red
wire). It is recommended to install an Earth Ground Wire. There are positions available on
the enclosure for this (Figure 52).
Fit the gasket (v), sealing (iii), and clip (ii) onto the sealing body (iv) (
Figure 47
).
Fit the lock (vi) and o-ring (ix) onto the housing (vii) (
Figure 47
).
Figure 47: Steps 3 and 4
Screw the sealing nut (i) and the assembled housing (x) onto the assembled sealing body (xi) with a
torque force of 8
–
10 kgf-cm (
Figure 48
).
Figure 48: Step 5
The assembly is now complete (Figure).
Figure 49: Completed assembly
Mount the completed cables into the keyed power module slot and the Ethernet module slot #8 and #9
from
Figure 41
.