ACTIVATING THE CARTRIDGE REPLACEMENT INDICATOR
Carry out the following steps with the kettle off the power base.
1. Connect the power base plug to a power socket.
2. Press the button to switch on the device. Then press the button and hold it down
for about 3 seconds; the symbol will appear on the display. This symbol indicates the
lifetime of the filter cartridge and remains visible on the display for 30 days when the device is
connected to the power socket.
3. When the 30 days have elapsed, the symbol will appear on the display.
4. After activating the cartridge replacement indicator, pressing the button again for about
3 seconds will reset the remaining life of the cartridge; the symbol will disappear from
the display.
SETTINGS:
MEASUREMENT UNIT °C / °F
The water can be shown on the LCD display in degrees Celsius or Fahrenheit.
With the appliance on, press the “°F/°C” button; the measurement unit (°C or °F) will appear on
the display. Press the “°F/°C” button to change the measurement unit.
SILENT MODE
The appliance normally beeps whenever a button is pressed. It can be set to silent mode.
Switch on the appliance, press the button, then press the button and hold it down for
about 3 seconds; will appear on the display.
To activate the beep, press and hold the button.
Caution:
when silent mode is set, the appliance beeps when boiling is finished or
when there is an alarm.
USING THE PRODUCT
NEVER
connect the kettle to a power socket when it is empty.
DO NOT
use the appliance for any purpose other than boiling drinking water.
Other liquids can contaminate the inside of the kettle.
DO NOT
fill the kettle when the power base is already connected to the power
socket.
DO NOT
fill the appliance above the MAX level mark. Overfilling may cause water
to spill out when it boils.
DO NOT
attempt to connect other appliances to the power base, and do not
tamper with the connector in any way.
The kettle was designed to boil and filter at the same time.
To ensure that the
appliance does not start heating when it is dry, wait a few minutes
before pressing the
button to let the filtered water fill the bottom of
the kettle up to the minimum (MIN) level.
The kettle has an internal safety
cut-out that turns it off if there is not enough water when it is switched on. In this
case, disconnect the plug from the power socket and let the appliance cool down.
1. Place the power base of the kettle on a flat, dry, heat-resistant surface.
2. Open the kettle by removing the lid and fill it with water up to the maximum level (“MAX” mark
on the tank).
Caution!
To avoid damaging the heating element, there must be no less than
0.5 litres of filtered water, and it must not exceed the total capacity of 1.5 litres to prevent hot
21
EN
EN
English
English
IT
IT
Italiano
Italiano
FR
FR
Français
Français
DE
DE
Deutsch
Deutsch
ES
ES
Español
Español
Summary of Contents for ISEO KJ4000W
Page 63: ......
