LAI Games Stacker Vendor, Operator'S Manual

Page: 19 / 62

Operator's Manual – Stacker Vendor
©
LAI GAMES
Page 14
PRESS START
to change value
1, 2, 3, 4 … 10
0 1 P P P P P 2 3 P
1
O n
PROGRAMMABLE ADJUSTMENTS MODE
The Stacker Vendor has twenty three programmable adjustments that can be changed
in this mode. They are P01 to P23 and their codes and values are displayed
alternatively during the adjustment procedure.
Example: Code P01 (Number of Coins Mech 1) is displayed as P 0 1 and its
value of 1 as
1
on the 4-digit display.
PROGRAMMABLE ADJUSTMENTS MODE DIAGRAM
PROGRAMMABLE ADJUSTMENTS PROCEDURE
ENTER The Programmable Adjustments Mode can be entered by pressing the
Test button once while in the Run Test or by pressing the Test button
four times while in Attract mode,
P P P P
will be displayed on the 4-
digit credit display.
SELECT The green Service button is pressed to step through each of the
adjustment configurations, starting from the
P P P P
display, P01
being the first step, continuing through to P23, and then looping again
from P01 to P23 until the mode is exited.
CHANGE The Start/Stop button is pressed to change the displayed value. The
value can only be stepped up by using the Start button, but the value
will loop back to its minimum value the next step after its max value.
EXIT The Programmable Adjustments mode is exited into Audits mode, by
pressing the Test button once.
RUN TEST MODE
PRESS TEST
PROGRAMMABLE ADJUSTMENTS MODE
PRESS
SERVICE
PRESS
SERVICE
REPEATEDLY
To step from
P01 to P23
AUDIT MODE
PRESS TEST
* NOTE! *
„
Certain program adjustments have a fast adjustment feature. By holding the
Start/Stop button down, the values step through quicker.
Loops back to P01