33
PX|22 Sheartec:II Planer \ Maintenance
Poly-V-Belt Adjustment
WARNING
·
TURN PLANER OFF AND DISCONNECT POWER BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS!
Poly-V-belt (Fig. 22, D) tension has been set at the factory. If the belt has stretched and needs adjustment.
1. Disconnect machine from power source.
2. Open lower rear, and lower left-hand side
panels. Loosen and tighten four adjustment
nuts (Fig. 22, D) to move motor plate up, or
down to increase, or decrease belt tension.
3. Tighten nuts against motor plate after
adjustment is made.
4. Belts are tensioned properly when moderate
finger pressure can deflect the v-belts about a
1/4"-1/2” midway between the pulleys.
FIGURE 22: POLY-V-BELT ADJUSTMENT
Summary of Contents for PX|22 Sheartec:II
