laguna MPSP12-5-0135, Owner'S Manual

Page: 19 / 67

(1) Changing Main Blade
The main blade size for this machine 12" , it is as option.
Any time you change the blade size, adjust the riving knife
to 3mm away from the blade you install.
1. Disconnect the power source.
2. Move the blade tilt to 0° (blade 90° to blade) and raise
the main blade as far as it will go.
3. Move the sliding table all the way forward to expose
the internal blade guard that covers the blades and
riving knife. (Fig. 42)
4. Pull the blade guard away from the blades to expose
the mounting assembly.
5. To remove the main blade, use the arbor wrench to
remove the arbor nut and arbor flange. (the arbor nut
has left hand threads and loosens by turning close wise.)
6. Install the new blade, re-install the arbor flange and the
arbor nut and tighten them against the blade. (Fig. 43)
Wear gloves to protect your hands when
installing or removing blades.
7. Move the orange blade guard back into its original
position, next to the blades and center the sliding table.
(2) Riving Knife Adjustment
Whenever the blade is changed, then riving knife must
be adjusted to 3mm away from the blade you install.
1. Disconnect the saw from power source
2. move the blade tilt to 0° (blade 90° to table) and raise
the main blade as far as it will go.
3. Move the sliding table all the way forward to expose the
internal blade guard that covers the blades and riving knife.
4. Pull the blade guard away from the riving knife to
expose the mounting assembly.
5. Loose the riving knife center bolt, slide the riving knife
away from the blade and slightly tighten. (Fig. 44)
6. Position the riving knife about 3mm or 1/8" away from
the nearest carbide tooth on the main blade. (Fig. 45)
7. Tighten the center bolt to secure the riving knife in position.
8. Move the blade guard back to its original position, and
move the sliding table to center.
16
WARNING
Fig.45-1
Vertical
All manuals and user guides at all-guides.com