laguna MPSP12-5-0135, Owner'S Manual

Page: 14 / 67

(9) Cross table
Crosscut content
：
Crosscut table x 1
Crosscut table brace x 1
T-nut M8-1.25 x 2
T-nut M12-1.75 x 1
Flat washer 12mm x 1
Adjustment handle M12-1.75 x 55 x 1
Knob M8-1.25 x 25 x 2
Fig. 17
Flat washer 8mm x 2
1.Thread the M12-1.75 x 55 adjustable handle with a
12mm flat washer through the crosscut table and into a
M12-1.75 T-nut. (Fig. 17)
2. place the extension table on the pivot pin of
the swing arm and slide the T-nut into the
T-slot in the sliding table.
3. Slide two M8-1.25 T-nuts into the crosscut table brace.
4. Align the T-nuts in the crosscut table supporter with
the holes in the crosscut table and thread the
M8-1.25 x 25 knobs, with 8mm flat washers, into the
T-nuts (Fig. 20)
(10) Crosscut fence
Crosscut fence content
：
Crosscut fence x 1
Crosscut fence support plate x 1
Center stud M8-1.25 x 10 x 1
Fiber washer 8mm x 1
T-nut M8-1.25 x 2
Knob M8-1.25 x 25 x 1
Knob M8-1.25 x 1
T-bolt M8-1.25 x 60 x 1
Flat washer 8mm x 1
Lock washer 8mm x 2
Button head screw M8-1.25 x 16 x 2
1. Thread the center stud and the fiber washer into the
remaining M8-1.25 T-nut.
2. Sliding the center stud, and M8-1.125 x 60 T-bolt and
screw M8-1.25 x 25 knob into the crosscut fence (Fig. 21)
3. Slide the center stud to the end with the plastic cap and
tighten it in place.
11
All manuals and user guides at all-guides.com